Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary current source

Posted Feb 9, 2012, 7:37 p.m. EST Low-Frequency Electromagnetics Version 4.2a 0 Replies

He Huang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I am using ACDC module and I want to know how to create a high frequency current source to observe the current flow in the model.
Basically, I drew two surfaces inside the solid and apply a positive boundary current source to one surface and a negative current source with same amplitude to the other surface. But the result didn't show any electrical potential change or current flow inside the model.
Instead, if I apply a voltage potential to one surface and make the other one as the ground, the result came out well.
can anybody help me?
0 Replies Last Post Feb 9, 2012, 7:37 p.m. EST
COMSOL Moderator

Hello He Huang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content