Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Material properties dependent on two parameters
Posted Feb 10, 2012, 4:51 p.m. EST 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I'm familiar with using say a function to set a material property that is dependent on one variable (i.e., temperature), but how would I go about setting it for two variables? Would I simply write two functions under the same material? Would Comsol then use both functions for its output?
Kind regards,
Jeff
I'm familiar with using say a function to set a material property that is dependent on one variable (i.e., temperature), but how would I go about setting it for two variables? Would I simply write two functions under the same material? Would Comsol then use both functions for its output?
Kind regards,
Jeff
1 Reply Last Post Feb 11, 2012, 4:19 a.m. EST
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I would say as for 1 variable, use a 2 argument entry for your table / interpolation function or analytical function, check the material library, there are materials depending on both T and p
--
Good luck
Ivar
I would say as for 1 variable, use a 2 argument entry for your table / interpolation function or analytical function, check the material library, there are materials depending on both T and p
--
Good luck
Ivar