Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

"Failed to generate mesh for domain" - from imported inductor component.

Posted Jun 5, 2020, 9:41 a.m. EDT Electromagnetics, Low-Frequency Electromagnetics, RF & Microwave Engineering, Structural & Acoustics, General, Geometry, Mesh Version 5.1 1 Reply

NV C
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I have an imported .stp file that is a small inductor.

I am trying to make a mesh out of it (and then eventaully find the magnetic field it produces with current running through it, which I am unsure as how to do as well) but am getting the error:

A problem occurred when building mesh feature 'Free Tetrahedral 1'

Failed to generate mesh for domain. - Domain: 2 Internal error in boundary respecting.

I have also tried using the "repair" feature from the defeaturing and repair section, but that has not helped. Below is a picture of my mesh. I am using COMSOL 5.1 and have attached the file.

here is the picture of my mesh: https://imgur.com/a/I3tUuF7

1 Reply Last Post Jun 5, 2020, 1:12 p.m. EDT
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago Jun 5, 2020, 1:12 p.m. EDT

Please attach your .mph file, not .mph.lock file.

Jeff

-------------------
Jeff Hiller
Please attach your .mph file, not .mph.lock file. Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content