Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Error under PDE mode after version upgrade
Posted May 29, 2012, 12:46 a.m. EDT Version 3.5a, Version 4.0 0 Replies
Please login with a confirmed email address before reporting spam
I have made some cases under PDE mode of 3.4 version before. Recently I upgrade Comsol version to 3.5a. However Error (fail to find consistent initial value) shows up when I run the previous cases under 3.5a version. All the settings in the simulation seem to be consistent with that shows under 3.4 version. And all the cases still runs well under version 3.4 in another computer.
Did anyone have experience in this situation? Any suggestion or help will be appreciated. Thank you.
Hello Derek
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.