physical settings of high-frequency electrode design

Please login with a confirmed email address before reporting spam

Hello,

I am designing a component with high-frequency GS electrodes (~50 GHz) in RF module.

As shown in the attached figure, I would like to simulate the probe connected above the Pads. Currently, I am using a Lumped Port (Uniform) design placed between two TBC and located at the center cross-section of the Pad. The outermost boundary of the simulation region is set with SBC. I would like to know if the setup is correct or if there are areas that need improvement (including physics, mesh & study).

My explanation may not be detailed enough, but you can refer to the attachment for more information.

Best regards,



0 Replies Last Post Apr 10, 2025, 3:46 a.m. EDT
COMSOL Moderator

Hello Larry Lai

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.