Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

mapped and swept meshing

Posted Dec 18, 2014, 5:30 p.m. EST Mesh Version 4.4 3 Replies

Karan Bikkannavar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am interested in generating mapped and sweep mesh( or structured mesh) for a 3d geometry which is simple(attachment)

Any suggestions?

Attachments:

3 Replies Last Post Dec 19, 2014, 3:33 p.m. EST
Steve Conrad
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago Dec 18, 2014, 7:08 p.m. EST
Here you go. The two domains have to be meshed separately.

--
Steven Conrad, MD PhD
LSU Health
Here you go. The two domains have to be meshed separately. -- Steven Conrad, MD PhD LSU Health

Attachments:

Karan Bikkannavar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago Dec 19, 2014, 12:23 p.m. EST
Thank you very much. I really appreciate it.

Unfortunately I dont have the latest version of COMSOL you are using. So I am unable to open the case in 4.4.
It would be great if you could resend it from version 4.4.

Thanks again.

Thank you very much. I really appreciate it. Unfortunately I dont have the latest version of COMSOL you are using. So I am unable to open the case in 4.4. It would be great if you could resend it from version 4.4. Thanks again.
Steve Conrad
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago Dec 19, 2014, 3:33 p.m. EST
Unfortunately I dont have the latest version of COMSOL you are using. So I am unable to open the case in 4.4.
It would be great if you could resend it from version 4.4.


I just happen to have 4.4 still installed, See attached.


--
Steven Conrad, MD PhD
LSU Health
[QUOTE]Unfortunately I dont have the latest version of COMSOL you are using. So I am unable to open the case in 4.4. It would be great if you could resend it from version 4.4. [/QUOTE] I just happen to have 4.4 still installed, See attached. -- Steven Conrad, MD PhD LSU Health

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content