Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Optimization

Posted Dec 13, 2015, 7:15 a.m. EST Fluid & Heat, Computational Fluid Dynamics (CFD), Chemical Reaction Engineering Version 5.0, Version 5.1, Version 5.2 0 Replies

Krishnaswamy Veluswamy
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I have run an time dependent optimization. I have set up the problem and ran the simulation along with the optimization module.

Again when I insert the new optimised values for the parameters, and again start the simulation, I am not getting the expected results. and is the same as previous simulation output.

Please provide me valuable suggestions.
0 Replies Last Post Dec 13, 2015, 7:15 a.m. EST
COMSOL Moderator

Hello Krishnaswamy Veluswamy

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content