C. Wolluschek, F. Etcheverry, M. Cachile, and J. Gomba
Mecánica de Fluidos e Ingeniería Térmica, Centro tecnológico Cemitec, Noáin, Navarra, Spain
Grupo de Medios Porosos, Facultad de Ingeniería, UBA, Buenos Aires, Argentina
Instituto de Física Arroyo Seco, UNCPBA, Tandil, Argentina.
In this work, a COMSOL model that predicts velocity and concentration fields inside an X-shaped millichannel (4 mm diameter) is developed. Water and a ink low concentration are injected simultaneously in the two inlets of the device. The mass transfer problem is solved by a Fickian model (solute concentration is low compared with the solvent). The parameters in this study are: initial inlet mass ...
Evaluation of COMSOL as a Tool for Pinpointing Moisture Entering Locations From Inside Surface Moisture
J. van Schijndel
Eindhoven University of Technology, Eindhoven, Netherlands
The location and nature of the moisture leakages are sometimes difficult to detect. Moreover, the relation between observed inside surface moisture patterns and where the moisture enters the construction is often not clear. The objective of this paper is to investigate inverse modeling techniques as a tool for the detection of moisture leakage locations in building constructions from inside ...
AkerSolutions, Fornebu, Norway
In COMSOL Multiphysics it is possible to implement and simulate several independent models in parallel. This can be meaningful when the different models are coupled to each other by some kind of interaction. If a part of the geometries is identical in all models, this part can be reduced in that it is implemented in only one of the geometries. In the other geometries only its solution towards ...
J. Berges, B. Barelaud, I. Niort, and J.L. Decossas
XLIM, Limoges, France
Université de Limoges, France
We propose the study of an electronic sensor allowing the collection of sprays in free space. The detector consists of three elements: a photodiode situated in the center of the structure to which is applied a bias voltage, an aluminum ring which referenced to a voltage higher than that of the photodiode and an insulating material disk (polyvinyl chloride). The total size of the structure is ...
Center for Product Development, Mads Clausen Institute, South Danish University, Denmark
This paper will give a short overview of use of COMSOL Multiphysics for analyzing ancient Greek and Roman catapults with the main focus on the energy storing torsion springs. Catapults have been known and used in the Greek and Roman world from around 399 BC and a fully standardized design for powerful torsion catapults emerged around 270 BC, based on one basic factor, the diameter of the torsion ...