See How Modeling and Simulation Is Used Across Industries
Multiphysics modeling and simulation drives innovation across industries and academia — as is evidenced by the many uses showcased in the technical papers and posters presented by engineers, researchers, and scientists at the COMSOL Conference each year.
Draw inspiration from the recent proceedings collected below, or, to find a specific presentation or filter by application area or conference year/location, use the Quick Search tool.
View the COMSOL Conference 2025 Collection
The determination of the modes of vibration of Functionally Graded-Metal-Ceramic Composite plates is important in practice in order to prevent undesired resonances in structural components. This paper describes the application of COMSOL Multiphysics® software for the determination of the ... Read More
A installation caused severe hum, with 30 Hz as dominant frequency, causing serious annoyance. The acoustic study showed resonances around 30 Hz. Poor flow conditions existed at the inlet and outlet of the forced draft fan. Flow patterns were studied using CFD. Both the inlet and ... Read More
In this contribution we present a COMSOL Multiphysics® example of a disk piezoelectric ceramic transformer (D-PT) coupled with a bipolar NPN transistor to form an auto-oscillator. The comparison between the simulations and the measurements made on our prototype are found to be in good ... Read More
High-intensity discharge lamps will in the foreseeable future be important light sources despite a growing market share of LEDs. Cost and energy efficient high frequency (300 kHz) operation is hampered by the excitation of acoustic resonances inside the arc tube, which results in low ... Read More
Absorber tubes are one of the most critical components of parabolic trough Concentrated Solar Plants, which is very likely get damaged such as crack and mass loss. Therefore, the monitoring of their structural health via Non-Destructive Testing (NDT) techniques is regarded as essential ... Read More
Axisymmetric acoustic waves propagating along buried water pipes have been investigated by FEM and experimentally. Universal dispersion relations of the fundamental mode were obtained as a function of the standard dimension ratio SDR and of the material surrounding the pipe (soil, air). ... Read More
Vibration produced by offshore wind turbines during their normal operation transmits through the tower into the foundation where it interacts with the surrounding water and is released as noise. The noise produced by offshore wind turbines can be detected by fish and marine mammals and ... Read More
Sound energy distribution patterns within enclosed spaces are the basic concerns of architectural acoustics. Energy decays are analyzed for major acoustical parameter estimations, while spatial energy distribution and flow vectors are indicative in the analysis of sound energy ... Read More
While musical instruments often rely on a body which resonates on purposefully to amplify the vibration produced by a string or a membrane, such as in a violin or a guitar, loudspeaker cabinets should not contribute at all to the total sound radiation, but aim instead to be a perfectly ... Read More
The approach of this project is Modeling a Coriolis Mass Flow-meter (CMF) bases on a Fluid-Structure Interaction (FSI) device. The "Coriolis mass flow-meter sensor" is modeled using COMSOL Multiphisics® simulation, the Acoustic-Shell Interaction physics interface and coupled by FSI ... Read More