See How Multiphysics Simulation Is Used in Research and Development
Engineers, researchers, and scientists across industries use multiphysics simulation to research and develop innovative product designs and processes. Find inspiration in technical papers and presentations they have presented at the COMSOL Conference. Browse the selection below or use the Quick Search tool to find a specific presentation or filter by application area.
View the COMSOL Conference 2024 Collection
A solar cell offers a potential solution to energy shortage problems by converting sunlight into electrical power. Organic solar cells (OSCs) are low-cost and versatile, but also tend to be low-efficiency and short-lasted. Three macroscopic parameters determine their power-conversion ... Read More
β heat treatment of Uranium rods is carried out for randomization of oriented grains (called texture) developed during hot rolling or hot extrusion operation. During this process, Uranium rods undergo heating of up to 740 Deg C followed by water quenching. The objective of this work is ... Read More
Magnetic Particle Imaging (MPI) is a new imaging technology based on the non-linear magnetisation of magnetic nanoparticles which can be used as a tracer material. In a high speed 1D MPI Device, a sinusoidal signal containing a single frequency generate a time-varying magnetic field via ... Read More
Micro Mirrors is a versatile device which has been gaining popularity and this finds application in fields such as optical switching, display and in medical fields for non-invasive imaging. A thermally actuated mirror moves in either positive or negative directions of x and y. The ends ... Read More
The discharge properties in low pressure inductively coupled Ar/CH4 plasmas operating at an RF frequency of 13.56 MHz and total gas pressure of 20 mTorr are studied in this work. The calculation of gas flow is performed in coupling with the plasma simulation. The gas flow rate is varied ... Read More
It is a complex problem to calculate the photonic crystal fiber model, and the methods of plane wave expansion, Hermite-Guasssian function and beam propagation have been analyzed. Finally the multipole method is adopted for solving problem. The hexagonal air holes in cladding have been ... Read More
Normal conducting cavities are typically used in the front end of proton accelerators to get the beam accelerated to velocities approximately a few tenths of the speed of light, where superconducting cavities can then be used to accelerate the beam to the speed of light. The warm part of ... Read More
The paper presents the numerical analysis of quench propagation in a DH magnet wound with a commercially available MgB2 wire in a fiber-glass composite matrix and operating at 20 K. The quench is induced by a small heater located on the first layer of the magnet close to the peak field ... Read More
Magneto-Hydrodynamic (MHD) power generation systems were originally investigated starting from the fact that the interaction of a plasma with a magnetic field must take place at much higher temperatures than could be observed in a mechanical turbine. The main problems of traditional MHD ... Read More
We simulate a Capacitive Micromachined Ultrasound Transducer (CMUT) using COMSOL Multiphysics® software. The CMUT is an electromechanical system, therefore, we couple the physics of electrical and structural mechanics to describe its dynamics. We obtain the distributions of the electric ... Read More