Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Injection of fluid into a porous medium

Posted Jun 20, 2017, 11:18 a.m. EDT Fluid & Heat, Porous Media Flow, Structural Mechanics Version 5.2 0 Replies

Ketan Hasija
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have taken a rectangular porous block and want to inject a fluid at a particular injection rate (m^3/sec) at a point on the left face of the block to enter into the block and see the pressure change and the seepage area. I used the poroelasticity module and defined the required parameters but it is showing the incorrect result. Please guide or send the required file for 5.2 version if anybody has done the work in the same field.
0 Replies Last Post Jun 20, 2017, 11:18 a.m. EDT
COMSOL Moderator

Hello Ketan Hasija

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content