Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

heat transfer during induced slug flow in partially filled pipe

Posted May 13, 2011, 1:12 a.m. EDT Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD) Version 4.1 0 Replies

Satyanarayan Dev
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to simulate heat transfer during highly turbulent induced slug flow in a half filled pipe line. I have coupled the Turbulent Multiphase flow - phase field physics with the non-isothermal flow physics. I have tried every possible combination of mesh size and boundary/initial conditions, but I keep on getting the error message "Unable to find consistent initial values" after running the simulation for several hours.

Please help me with this.

Thank you in advance
0 Replies Last Post May 13, 2011, 1:12 a.m. EDT
COMSOL Moderator

Hello Satyanarayan Dev

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content