Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

mesh at the boundary

Please login with a confirmed email address before reporting spam

I tried to use extra fine at my boundary point but when I did mesh, it showed the error : there is no feature using these settings. I'm using comsol 4.2

There is no such problem in 3.5.

Anyone knows why this happens? Thank you very much!

1 Reply Last Post Sep 26, 2011, 1:48 a.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Sep 26, 2011, 1:48 a.m. EDT
Hi

I believe you have missed the node definition, perhaps the selection is wrong, or you do not have the same selection for the mesh and the "size" sub-node, or some inconsistiencies therearound

--
Good luck
Ivar
Hi I believe you have missed the node definition, perhaps the selection is wrong, or you do not have the same selection for the mesh and the "size" sub-node, or some inconsistiencies therearound -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.