Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Results Presentation

Posted May 16, 2012, 8:16 p.m. EDT Structural Mechanics Version 4.2a 1 Reply

Atma Bhawuk
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi.

I am using COMSOL 4.2a to simulate tensile loading conditions.

If I do a prescribed displacement test and get the 3D plot for von Mises stress distribution, and the 3D plot for deforamtion (length) after the specimen has reached the prescribed displacement, how can I show a 2D plot of Force versus displacement?

AB
1 Reply Last Post May 17, 2012, 2:13 a.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago May 17, 2012, 2:13 a.m. EDT
Hi

check the Results Derived Variables, and make a few tables with the relavant results, then you can easily plot these table values (even in a single icon click)

--
Good luck
Ivar
Hi check the Results Derived Variables, and make a few tables with the relavant results, then you can easily plot these table values (even in a single icon click) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content