Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
applyingfrequency
Posted Jun 20, 2012, 2:47 a.m. EDT MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.0a 1 Reply
Please login with a confirmed email address before reporting spam
can i directly apply frquency to the model? how?
1 Reply Last Post Jun 20, 2012, 3:31 p.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
it depends what you want to do: if you want to analyse a transient situation you should use a time stepping and define your loads or other BC's with a time varying equation.
but if you have a steady state oscillation (harmonic response) use the frequency domain solvers which does a development in omega and omega square, you define the frequency or frequency span/range in the solver setting.
Check the equations to understand how the equations look like in time series and frequency sweep solver modes
--
Good luck
Ivar
it depends what you want to do: if you want to analyse a transient situation you should use a time stepping and define your loads or other BC's with a time varying equation.
but if you have a steady state oscillation (harmonic response) use the frequency domain solvers which does a development in omega and omega square, you define the frequency or frequency span/range in the solver setting.
Check the equations to understand how the equations look like in time series and frequency sweep solver modes
--
Good luck
Ivar