Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

What kind of strain or stress should I be reading in the results for piezoelectric simulation

Posted Oct 26, 2012, 2:44 p.m. EDT MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.3a 0 Replies

Lionel Wong
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am doing a piezoelectric simulation and using a force, I have displaced the piezoelectric cantilever. However, in the results section, I'm not sure which type of strain should I be looking at as there are so many options available. I just want to know the typical strain in the x direction (1-dir) and z-dir (3-dir). Thanks.

Regards,
Lionel
0 Replies Last Post Oct 26, 2012, 2:44 p.m. EDT
COMSOL Moderator

Hello Lionel Wong

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content