Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Comsol axisymmetric problem

Posted Mar 31, 2010, 4:25 a.m. EDT 1 Reply

EMANUELA CACIULAN
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi
I want to model an 2D axisymmetric solenoid in a magnetostatic conditions, but when I want to put the boundary settings I can not see it, it doesn't appear at the physics.

Thanks,
Ema
1 Reply Last Post Mar 31, 2010, 3:24 p.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Mar 31, 2010, 3:24 p.m. EDT
Hi

I'm not sure I catch fully your problem, but if it is that you want to define some physics on an interiour boundary, that normally are greyed out as the default conditions are "continuity", you must turn them "ON" by selecting the check box just below the boundary item list, next to the "not active here"

Hope this helps
Good luck
Ivar
Hi I'm not sure I catch fully your problem, but if it is that you want to define some physics on an interiour boundary, that normally are greyed out as the default conditions are "continuity", you must turn them "ON" by selecting the check box just below the boundary item list, next to the "not active here" Hope this helps Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content