Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Permanent magnet -field avoiding some iron

Posted Jul 6, 2015, 4:02 a.m. EDT Low-Frequency Electromagnetics Version 5.1 0 Replies

Matthew Kurth
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I created a geometry of an iron return yoke and 2 magnets, but the field seems to only go through half of the iron and avoids the other half. As far as I can tell I assigned all the iron as the same. Anyone have a clue what I'm missing?
0 Replies Last Post Jul 6, 2015, 4:02 a.m. EDT
COMSOL Moderator

Hello Matthew Kurth

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content