See How Modeling and Simulation Is Used Across Industries
Multiphysics modeling and simulation drives innovation across industries and academia — as is evidenced by the many uses showcased in the technical papers and posters presented by engineers, researchers, and scientists at the COMSOL Conference each year.
Draw inspiration from the recent proceedings collected below, or, to find a specific presentation or filter by application area or conference year/location, use the Quick Search tool.
View the COMSOL Conference 2025 Collection
The Hyperloop is a concept system targeting passenger transportation aiming to carry people in a pod running in a high vacuum tube at 1200 km/h. In 2015, SpaceX announced that they would sponsor a Hyperloop pod design competition, because of their interest in helping to accelerate the ... Read More
A 3D finite element model (FEM) of the PEMC sensor was developed to characterize the modes of vibration that have demonstrated high sensitivity to mass-change in experimentally fabricated sensors. The fundamental bending mode of vibration and the 1st bending harmonic are predicted at 10 ... Read More
In this study, COMSOL Multiphysics was used for the reliability evaluation for static chamber method at landfill sites. Static chamber method, which measures landfill gas emission fluxes, is widely used at landfill sites for the monitoring of greenhouse gas emission such as methane and ... Read More
A beneficial method for transporting highly viscous hydrocarbons (e.g. heavy oil and bitumen) through a pipeline is known as Lubricated Pipe Flow (LPF). A major challenge for this technology is flow instability caused by the formation of a wall-coating of oil or the thinning and/or loss ... Read More
As a key component of MEMS, microprocessor with high computing performances is facing with severe thermal challenge due to the increasing power density, miniaturization as well as higher operating temperature requirements, and thermal management in corresponding fields has become one of ... Read More
In the framework of the Austrian FFG project SaLüΗ!, a compact mechanical ventilation system with integrated micro-heat pump was developed. The aim was a high level of prefabrication and a compact design allowing for installation also in small flats, e.g. into the façade. Due to the ... Read More
Phosphoric acid doped polybenzimidazole (PBI) membranes are commonly used in today’s high-temperature polymer-electrolyte-membrane (HTPEM) fuel cell technology. COMSOL Multiphysics is used to model and simulate the three-dimensional, single-phase, non-isothermal overall cell behaviour ... Read More
In recent times, the major concern in the area of microelectronics is efficient heat transfer which will improve the operating characteristics of the device as well as minimize its failure rate due to induced overheating. The removal of excess heat from the system can be done by ... Read More
Surfaces with water contact angle greater than 150º are super-hydrophobic in nature and possess extraordinary water repelling properties. Various researches on wettability of textured surfaces in recent years have shown that texturing surfaces with micron-sized and nanosized patterns ... Read More
Hydrocyclones are industrial devices used as processing units in fluid and particle technology. A hydrocyclone is an apparatus consisting of a cylindrical or a cylindrical-conical body with a tangential or involute entrance to admit the fluid inside. There are also two opposite exits, ... Read More