Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Assign a surface impedance

Posted Feb 9, 2017, 5:47 a.m. EST Version 5.1 1 Reply

Guillaume Laporte
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to model a surface impedance. I did the model with HFSS and I represented the surface impedance using a thin layer and I assigned a boundary condition. However, I am unable to do the same with COMSOL. Is there a way to assign a surface impedance?

* Calculate an equivalente layer ? (I tried but the results were wrong)
* Assign a boundary condition ?

Thank you,
Guillaume
1 Reply Last Post Feb 9, 2017, 1:30 p.m. EST
Dave Greve Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago Feb 9, 2017, 1:30 p.m. EST
In Comsol it is not necessary to define a thin layer, just use the impedance boundary condition.

DWGreve
DWGreve Consulting
In Comsol it is not necessary to define a thin layer, just use the impedance boundary condition. DWGreve DWGreve Consulting

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content