Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Proper use of General Extrusion's Destination Map

Posted Mar 7, 2011, 8:47 a.m. EST Studies & Solvers Version 4.0 0 Replies

Omer Salomon
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone,

I need a little help with using COMSOL 4.0's General Extrusion's Destination Map section.
I select the desired boundaries (For a boundary-type extrusion) and I name the operator, but I don't know what to type inside Destination Map's x-expression,y-expression.
Specifically, The model I'm working on is transistor and I would like to perform a General Extrusion on Drain and Source boundaries.

Thanks a lot,
Omer
0 Replies Last Post Mar 7, 2011, 8:47 a.m. EST
COMSOL Moderator

Hello Omer Salomon

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content