Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Adding electrical circuit in 3D geometry

Posted Aug 31, 2017, 10:59 a.m. EDT Low-Frequency Electromagnetics Version 5.0 0 Replies

Shamor
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone. I am shamor. I have made an elliptical shape geometry containing a fluid (conductivity 1.5). My geometry has two long electrode (for current carrying) and four small electrode (for potential measurement). Small electrodes will be shorted with resistor from outside. And I want to measure the potential between two nodes of shorted electrode. For that i have read "Inductor in an Amplifier Circuit" in detail from AC/DC application builder. But I have been facing some problem with geometry node and my Lt spice circuit node.
What should I do now? Is there any alternative literature about that problem?

Regards
Shamor

Attachments:

0 Replies Last Post Aug 31, 2017, 10:59 a.m. EDT
COMSOL Moderator

Hello Shamor

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content