Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

parametric sweep initial conditions

Please login with a confirmed email address before reporting spam

Hello COMSOLer's ;

Currently I am tryig to simulate a stationary study of a plasma flow discharge with a parametric sweep ; since the geometry of the discharge gap is varying in each step. i remmember in previous COMSOL versions that A parametric sweep will typically reuse the previous result as initial conditions for the next parameter. This means that a different solving path is taken. However, i noticed some changes in the 5.3 version , which i am not sure if this function still available or not ?!

i hope if anyone could confirm or deny this info please ...

Best Regards ;


0 Replies Last Post Oct 2, 2018, 6:08 AM EDT
COMSOL Moderator

Hello Majida Wreikat

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.