Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Phase change temperature does not have an influence

Please login with a confirmed email address before reporting spam

Hello,

I am relatively new to Comsol and trying for a while now to simulate the influence of phase change materials on the temperature of a room. The simulation is only based on a heat transfer in regards to the processing time and produces quite reasonable outputs. However, the temperature of the phase change transition does not seem to have any effect on the temperatures both in the air of the room and the PCM itself.

Did anyone have this same problem and/or can help me to take a look at my model? I have attached the file below.

I would be very grateful!

Carmen



0 Replies Last Post Apr 15, 2019, 6:17 a.m. EDT
COMSOL Moderator

Hello Carmen Ramkhelawan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.