Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parametric Sweep

Posted Feb 14, 2022, 11:00 a.m. EST Version 5.3a 2 Replies

Aiman Memon
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear Concern,

Hope you are doing well.

I am working on an implantable drug delivery system. I used release rate ks=1e-6, 5e-6 and 25e-6 in parametric sweep, but all the time I get only one plot even though I select all from parametric sweep. I am using the COMSOL 5.3a version. Can you please guide me about this issue?

I am attaching the picture for your reference.

Hope to hear from you soon.

Attachments:

2 Replies Last Post Feb 16, 2022, 9:54 a.m. EST
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago Feb 14, 2022, 1:54 p.m. EST

Hi,

there are probably 3 identical curves and the red one is on top. So all parameter values gave identical results.

Cheers Edgar

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Hi, there are probably 3 identical curves and the red one is on top. So all parameter values gave identical results. Cheers Edgar
Aiman Memon
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago Feb 16, 2022, 9:54 a.m. EST

Hi Edgar,

Many thanks for your response.

Hi Edgar, Many thanks for your response.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content