Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
douts in comsol 4.3 version
Posted Sep 10, 2012, 3:01 a.m. EDT Version 4.3 1 Reply
Please login with a confirmed email address before reporting spam
Dear Sir,
Iam using comsol 4.3 version for pipeline inspection modelling (3D), We have one doubt , we would like to move the coil from one place to another place by step by step,Is it possible to move the coil automatically?If it is possible , please tell the procedure to move the coil from one place to another place with in the tube.
Thanking you sir
Iam using comsol 4.3 version for pipeline inspection modelling (3D), We have one doubt , we would like to move the coil from one place to another place by step by step,Is it possible to move the coil automatically?If it is possible , please tell the procedure to move the coil from one place to another place with in the tube.
Thanking you sir
1 Reply Last Post Sep 10, 2012, 7:58 a.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
if the "coil" you refer to is the geoemtry loop, yeas with an external Paramatric sweep node (add manually) you can change the geoemtry, but try to keep the topology similar
--
Good luck
Ivar
if the "coil" you refer to is the geoemtry loop, yeas with an external Paramatric sweep node (add manually) you can change the geoemtry, but try to keep the topology similar
--
Good luck
Ivar