Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Eddy current probe simulation

Hi all,
I'm new in COMSOL right now I'm doing eddy current crack signal processing. what I want to do is to use COMSOL to simulate crack signal then compare with actual experiment results.
but now I don't know what to start I read some papers but still have no idea what to begin with. can someone give me some similar model example to study?
probe: differential probe (two coils)
signal: impedance of probe
when encountered with crack the in the impedance panel the signal is a "8" shaped
Baoguang Xu

0 Replies Last Post Feb 21, 2013, 4:32 PM EST
COMSOL Moderator

Hello Baoguang Xu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.