Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Point Meshing (Ver. 4.0)
Posted Jul 6, 2010, 2:03 p.m. EDT 2 Replies
Please login with a confirmed email address before reporting spam
In version 4.0 is it still possible to mesh around a point? Any direction would be greatly appreciated.
Thanks
Thanks
2 Replies Last Post Jul 8, 2010, 1:36 p.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi,
It is possible. To create a finer mesh around a point, do the following steps:
1. Right-click the mesh node (typically Free Triangular in 2D) and select Size.
2. In the Settings window for the Size subnode, select Point from the "Geometric entity level" list.
3. Add the point where you want a finer mesh to the selection.
4. Select the Custom button in the Element Size section of the Settings window.
5. Specify the element size parameters (typically by selecting the "Maximum element size" check box and entering a suitable local mesh size.
6. Click the "Build All" button at the top of the Settings window.
Best regards,
Magnus Ringh
COMSOL AB
It is possible. To create a finer mesh around a point, do the following steps:
1. Right-click the mesh node (typically Free Triangular in 2D) and select Size.
2. In the Settings window for the Size subnode, select Point from the "Geometric entity level" list.
3. Add the point where you want a finer mesh to the selection.
4. Select the Custom button in the Element Size section of the Settings window.
5. Specify the element size parameters (typically by selecting the "Maximum element size" check box and entering a suitable local mesh size.
6. Click the "Build All" button at the top of the Settings window.
Best regards,
Magnus Ringh
COMSOL AB
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Magnus,
Thank you again for your help.
Cheers,
Jared
Thank you again for your help.
Cheers,
Jared