Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modelling a mixture in a centrifuge

Posted Jul 30, 2010, 3:26 p.m. EDT 0 Replies

Shahriar Khushrushahi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

Im trying to model the separation of a mixture in a centrifuge. I am setting up the problem as a 2D axisymmetric problem using the Mixture Model application mode.

I want to be able to set a phi directed velocity but I dont know how to do this. The Swirl module allows for setting the phi directed velocity but assumes a single phase fluid.

I cannot set the phi directed velocity in any of the boundary conditions using the mixture model application mode.

Any suggestions will be greatly appreciated
Shahriar
0 Replies Last Post Jul 30, 2010, 3:26 p.m. EDT
COMSOL Moderator

Hello Shahriar Khushrushahi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content