Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Lumped Port Impedance

Posted Apr 1, 2011, 12:07 p.m. EDT RF & Microwave Engineering Version 4.1 0 Replies

Michael Reilly
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying to figure out how COMSOL calculates the lumped port impedance? For my model, it did not make much sense. So I tried creating a simple 50 Ohm transmission line. Center conductor, dielectric, ground shield, with a lumped port excited on the input and a passive port on the exit. Instead of giving me a 50 Ohm impedance, it gives me a very non-believable 2000 Ohms....
0 Replies Last Post Apr 1, 2011, 12:07 p.m. EDT
COMSOL Moderator

Hello Michael Reilly

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content