Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Toroidal core
Posted May 16, 2012, 3:28 p.m. EDT 1 Reply
Please login with a confirmed email address before reporting spam
I have tried to model toroidal core made of wound steel sheet in 2D geometry. COMSOL 4.0 have been used. Previously, I have tried to model this in COMSOL 3.5 but it seems that Thin low permeability gap boundary condition does not work as it should. I think that this have been already discussed at this forum. That is why I decided to make the model in COMSOL 4.0. Since I am not completely familiar with COMSOL 4.0 I came across problems.
I post my model on the forum with asking those who are in this closely to look it and comment. Problem occurs when I try to solve the model. I do not know why this happens, due to bad Subdomain or Boundary, or something else. Maybe the whole model have been made wrong, or it should be made in 2D axial symmetry or 3D.
Best regards,
Branko
I post my model on the forum with asking those who are in this closely to look it and comment. Problem occurs when I try to solve the model. I do not know why this happens, due to bad Subdomain or Boundary, or something else. Maybe the whole model have been made wrong, or it should be made in 2D axial symmetry or 3D.
Best regards,
Branko
Attachments:
1 Reply Last Post May 16, 2012, 3:51 p.m. EDT